31
Discussion | Обсуждение / Re: Page break between Band and Subbands on single page
« on: December 10, 2022, 07:52:29 PM »
Hi! I have checked. For me all works as expected. Maybe you are expecting some other behavior?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
OK. So, unless I specify Reportpage1_DataBand1 in the code it will crash and this is normal behavior. That does not sound rightif we write somethig like this:
QObject* object = new QObject();
delete object;
qDebug() << object->objectName();
Will application crash be the normal behavior? I installed Qt using the Qt installer downloaded from qtioIt's very strange that you have a problem with private headers in case when you installed qt via installer.
The problem is when I click on report bands the drop down list is blank.I will check it. Possible is needed to create new AppImage for new linux versions.
Further if I try to compile it with QtCreator 8.0.1 the following errors occur:Have you tried to build source codes from https://github.com/fralx/LimeReport?
От части понял в чем проблема: при переходе (переносе данных отчета) на следующую страницу не учитывается информация о динамически изменившейся высоте элементовГенератор заранее не вычисляет количество строк, а наполняет элементами до полного заполнения пространства. Единственный элемент, который вычисляется заранее это футер страницы, вот он не способен кардинально менять свой размер. Ваш случай надо исследовать отдельно. Если вы сможете подготовить тестовые данные и прислать мне на почту (Arin_a@bk.ru) я попробую найти время и глянуть. Ваша задача хорошо решается через кросс таблицы, но в лайме на данный момент такой элемент не реализован.